Quick Answer: When Should Serpentine Belts Be Replaced?

How much does it cost to replace a serpentine belt?

A typical serpentine belt start at around $25 and goes up to $75 at most.

If you know some car repair basics, you could change the belt yourself, and it may save you paying labor charges somewhere between $75 and $120.

All together, you’re looking at around $100 to $195 to replace your serpentine belt..

Why do serpentine belts break?

The most serious failure is when the serpentine belt breaks completely. This is usually the result of a belt in poor condition, or a problem with one of the accessory components being driven by the belt. A failed bearing in a pulley being driven by the serpentine belt will also cause the belt to break.

Does Jiffy Lube replace serpentine belts?

To help, Jiffy Lube offers engine services with serpentine belt replacement that includes the following: … Removal of the old serpentine belt and installation of a new one.

What does a bad serpentine belt sound like?

Think you might have a bad serpentine belt? A telltale sign is that the engine squealing comes from the front of the vehicle and that it persists. Belt squeaking is also especially pronounced when accelerating, on startup, and when making a U-turn. The noise is loud and sounds like a squeal, loud chirp, or squeak.

Why is my brand new belt squealing?

You have an extra load somewhere causing the belt to slip. It could be a bad battery causing the alternator to work harder or it could be a power steering pump going bad causing the same thing. It could also be a worn bearing in one of the idler pulleys or the tensioner its self could be worn out.

How long does a serpentine belt last?

60,000 to 100,000 milesSerpentine belts are built to last—much longer than before because of advancements in rubber technology. Under ideal conditions, a belt should stick with you for an average of 60,000 to 100,000 miles. Pretty impressive. However, some belts are manually tensioned and may need to be adjusted.

Can I put WD 40 on a squeaky belt?

Spray just enough WD-40 onto the belt to lightly cover the area where the squeal occurs. … Oversaturating the belt will result in severe slipping, which can permanently damage the belt. WD-40 is a water displacement lubricant and should remove the moisture from the belt ribs.

Can antifreeze damage a serpentine belt?

Yes. Antifreeze will cause damage the rubber compound in the belts. If you do not replace it now then it will slip and may cause the water pump installer to not warranty the work.

How long can a car run without serpentine belt?

around 70-90 minutesOnce it reads “normal” it only takes a short time before it gets too hot. The battery on the other hand, will happily run the car and accessories on average around 70-90 minutes without the alternator, provided you don’t have headlights or anything high-drain on.

Will AAA replace a serpentine belt?

At AAA Owned and Operated Auto Repair, we perform the following belt services: Serpentine Belt Service Serpentine belts transfer power from the crankshaft to engine accessories, such as A/C, power steering, alternator, fan, and various other pumps and accessories.

How do you know when to replace the serpentine belt?

It is a good idea to physically inspect your serpentine belt from time to time. Check for cracks, chunks missing, abrasions, rib separation, uneven rib wear, and damaged ribs. If you notice any of these, it is time to replace your serpentine/drive belt.

Can you drive with a broken serpentine belt?

Under no circumstances can you drive a vehicle without a serpentine belt because the serpentine belt serves the important function of delivering antifreeze to important parts of the engine. The serpentine belt drives the water pump, and without it, there is insufficient coolant flow to maintain the engine temperature.

Can a bad serpentine belt cause check engine light?

A loose or worn belt will cause ticking or rattling noises, poor engine performance and overheating, usually triggering the check engine light. If the timing belt breaks, the engine can’t run — and on some engines that break can cause internal damage.

What to spray on belt to stop squeaking?

It’s not an easy fix for all squeaks. If your belt is slipping because the rubber is starting to dry out, then belt conditioner will stop the squeak by softening it and moisturizing it. If your belt is getting dried out, spray both sides with belt dressing and let it soak into the belt before spraying it again.

Is a serpentine belt easy to replace?

Serpentine belt replacement is easy because today’s automatic drive belt tensioners eliminate the need to loosen bolts or pry components into position for retensioning. Just rotate the tensioner, remove the old belt and install a new one.